Power UNITS FOR LIFT TABLE one
Common Description
This energy unit is made solely to the tiny lift table,Consisting of higher stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit has been extensively utilised while in the sector of logistic products like minifork lift, scissors lift and ariel working platforms. The lower-ing motion is controlled from the solenoid valve together with the pace managed through the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Basic Description
This energy unit is developed solely for the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve as well as the pace managed from the adjustable needle valve. Once the lift rises to a large positoin, however the electrical power supply is lower, the lowering movement is managed by the manual override perform.
Power UNITS FOR LIFT TABLE three
General Description
This energy unit is created exclusively for the substantial lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve plus the velocity managed by a strain compensated flow manage valve.
Energy UNITS FOR LIFT TABLE four
Common Description
This energy unit is made solely for that significant lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve and the velocity managed by the adjustable needle valve. Once the lift rises to a substantial positoin, but the power supply is lower, the lowering movement is controlled by the manual override function.
Distinctive Notes
1. This electrical power unit is of S3 duty cycle, which may only get the job done intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean the many hydraulic parts concerned prior to set up of the power unit.
3. Viscosity from the oil shoud be 15~46 cst,which ought to also be clean and totally free of impurities.N46 hydraulic oil is advised.
four. Oil changing is required following the preliminary a hundred operation hrs,afterwards as soon as each 3000 hours.
5. The energy unit proven is created to be mounted vertically.